CHAINTECH 9EJL4 User Manual page 31

Wake up Events
1. Power On By PCI/Onbrd LAN:
When enabled, a PCI interface that receives a signal will activate the system from
soft off and green mode.
2. Power On by Modem:
When enabled, a Modem will be able to receive a signal and activate the system
from soft off and green mode. You should connect the modem to the COM port and
call your PC to power on.
3. Wake up on LAN:
When enabled, a LAN that receives a signal will activate the system from soft off
and green mode.
4. USB KB Wake-Up From S3:
Allows the activity of USB device to wake up the system from S3 power saving
modes. Settings are [Enabled] and [Disabled].
5. Power On by Alarm:
When enabled, this setting allows the system to turn back on at specified date of
the month. User must designate date of month and time of day.
This function is only available when using an ATX power supply and the
Software Power-Off function to turn off the computer.
6. POWER ON Function:
This control gives PS/2 mouse or keyboard control to power on the system.
Available settings are [Password], [Hot KEY], [Mouse Move], [Mouse Click],
[Any KEY], [BUTTON ONLY] and [Keyboard 98].
7. KB Power ON Password:
If POWER ON function is set to [Password], then you can seta password for the
PS/2 keyboard to power on the system.
8. Hot Key Power On:
If POWER ON function is set to [Hot Key], you can assign hot key combinations
from [Ctrl –F1] to [Ctrl-F12] for the PS/2 keyboard to power on the system.
Chapter 3
27