CHAINTECH 9EJL4 User Manual page 27

support.
OnChip PCI Device:
This section provides information on setting the on-board devices. Press [Enter] to
enter the sub-menu, which contains the following items for advanced control:
1. AC97 Audio:
This feature allows you to enable/disable the on-board AC97 audio function.
Super IO Device:
This section provides information on setting the Super I/O devices. Press [Enter] to
enter the sub-menu, which contains the following items for advanced control:
1. Onboard FDC Controller:
Select Enabled if your system has a floppy disk controller (FDC) installed on the
system board. If you install an add-in FDC or the system has no floppy drive,
choose Disabled in this field.
2. Onboard Serial Port 1/2:
Select an address and corresponding interrupt for the first and second serial
ports. Available options are [3F8/IRQ4], [2E8/IRQ3], [3E8/IRQ4],
[2F8/IRQ3], [Disabled], and [Auto].
3. UR2 Duplex Mode:
Available options: [Half] and [Full].
4. Onboard Parallel Port:
Select a logical LPT port address and corresponding interrupt for the physical
parallel port.
5. Parallel Port Mode:
Select an operating mode for the onboard parallel (printer) port. Select SPP unless
you are certain your hardware and software support one of the other available
modes.
6. ECP Mode Use DMA:
This item automatically specifies a DMA channel 1 or 3 for the parallel port when
it is set to [EPP] or [ECP+EPP] mode.
7. PWRON After PWR-Fail:
Available options: [Off], [On], and [Former-Sts](Former Status).
8. Game Port Address:
This item disables or assigns the address of the Game port. Available options are
[201] and [209].
9. Midi Port Address:
This item disables or assigns the address of the Midi port. Available options are
[300] and [330].
Chapter 3
23