Chauvet SlimPAR PRO VW User Manual page 9

Lens Assembly Replacement
3. Setup
The SlimPAR™ Pro VW has an option available to replace the secondary LED optics, or lens
assembly. This will alter the beam and field angles of the fixture.
The wide angle lens assembly is installed at the factory. The narrow lens assembly is available
as an optional accessory.
Please see the steps below for instructions on replacing the lens assembly in the SlimPAR™ Pro
VW.
1. Remove the four Allen screws from the front trim ring with glass of the fixture. Use a #3
metric Allen wrench for this step.
2. After removing the screws, the front cover will come off. Remove it.
3. You now have access to the lens assembly. Use a Philips #2 screwdriver to remove
the four screws that hold it in place.
4. Carefully remove the lens assembly. The LEDs will now be exposed. Use caution to
prevent damage.
5. Place the new lens assembly in the fixture and reinstall the four Philips #2 screws.
6. Put the front cover in place and reinstall the four Allen screws.
Allen screw
Allen screw
Lens assembly
Front cover
9
Allen screw
Allen screw
11/24/2010 4:15 PM