Table of Contents
Advertisement
VIVOTEK
3. Connect cables and use sealants and putties to make sure cable joints and the cabling hole
are waterproof.
4. Secure the included ground wire to the dome cap, pass it through the mount bracket, and con-
nect the other end to a grounded conduit later.
5. Use the included hex wrench to secure the top section.
Mounting the Camera
1. Align the camera body with the top section. Align the alignment mark on the camera with that
on the interface section. Push the camera up to match the top section.
2. Rotate the camera clockwise until its alignment mark is aligned with the "C" mark.
3. Use the included T25 stardriver to tighten the 3 anti-tamper screws from the top. Make sure
all parts have been securely tightened.
2
12 - User's Manual
1
4
Alignment Mark
C Mark
3
Advertisement
Table of Contents
