Table of Contents
Advertisement
2.2 Installing the Switch
This part describes how to install your Fast Ethernet Switch and
make connections to it. Please read the following topics and
perform the procedures in the order being presented.
This Switch does not need software configuration.
Note
2.2.1 Desktop Installation
To install the Switch on desktop, simply follow the next steps:
Step 1:
Attach the rubber feet to the recessed areas on the
bottom of the Switch.
Step 2:
Place the Switch on desktop near an AC power
source.
Step 3:
Keep enough ventilation space between the Switch
and the surrounding objects.
When choosing a location, please keep in mind the
environmental restrictions discussed in Chapter 1,
Section 1.4 Product Specifications.
Note
Step 4:
Connect your Switch to network devices.
A. Connect one end of a standard network cable to the
10/100 RJ-45 ports on the Back of the Switch.
B. Connect the other end of the cable to the network
devices such as printer servers, workstations or
routers...etc.
Connection to the Switch requires UTP Category 5
network cabling with RJ-45 tips. For more infor-
mation, please see the Cabling Specification in
Note
Appendix A.
11
Advertisement
Table of Contents
