Advertisement
Some people find it more comfortable to use the up/ down arrows for programme zapping, and therefore
also benefits from this option, using a Beo4 or Beo5.
qqqqqq91 Yellow/ Blue is programme Zap.
qqqqqq90 Up/ Down is Programme Zap.
Installation - troubleshooting
The OneRemote EXT cable must be connected to the devices 'TV' scart output socket and a scart input
socket on the TV. Then the IR-emitter must be stuck in a way that it can emit IR-light in to the devices IR-
receiver, that normally receives the IR-light emitted from the devices own remote control.
Only scart input sockets can be used, that are able to send out linkdata to the EXT controller. Also the TV
must be programmed to send out data to the scart socket, which is done in the TV's 'Sources' menu. Refer
to the TV's user manual.
The EXT controller emulates DVD, VMEM, VTAPE, SAT, DTV, VAUX and other sources.
There is no programming needed on the EXT controller.
The scartplug in that end of the EXT cable where the power supply and
the IR-emitter cable is attached, MUST be inserted in to the devices
'TV' output. If not, the EXT controller might not be able to power on
and off the device correctly.
The EXT cable is equipped with a control LED build in to the scartplug, that is inserted in to the device. This
LED assists in faultfinding if something is not operating correctly.
w w w . o n e r e m o t e . d k
Page 6
Advertisement
