Advertisement
Control LED indications
Continous red or green flashing.
When power is applied to the EXT controller, the LED will start flashing. The flash
indicates that the EXT controller has not received a command data from the TV, since
power on.
As soon as a command is received from the TV, the LED will stop flashing and light solid
red or green.
If the control LED continues flashing after you have selected the source on the TV where the
cable is attached, the socket does not include control data or the TV has not been set up
correctly. Refer to the TV's user manual.
LED - colour.
The EXT controller will light red when it has detected a device that is powered on. It
will either flash or light solid red.
The EXT controller will light green when it is not connected to a device or if it is
connected to a device that is powered off.
If not connected to the TV output socket of a device, the EXT controller will not be able
to measure if the device is powered on and therefore always light green.
LED - short flash off.
During use the LED will light red or green, depending on the powerstatus of the device.
When receiving a controldata from the TV, the control LED will shortly go out to
indicate this. If a button is pressed on the TV's remotecontrol supposed to operate the
device and the LED does not indicate this, the TV has not been correctly set up.
w w w . o n e r e m o t e . d k
Page 7
Advertisement
