Sharp AL-1552 Operation Manual page 50

Setting a large original (AL-1552)
The original cover can be removed to allow copying of bulky objects.
1
Simply lift the original cover straight
up.
2
To reattach the original cover, reverse the above procedure.
Using the SPF/RSPF
The SPF is designed to hold up to 30 originals measuring from A5 to A4 and
weighting from 52g/m
• Before feeding originals in the original feeder tray, be sure to remove
• Before placing curled or wavy originals into the original feeder tray, be
• The SPF/RSPF (
• Badly damaged originals may misfeed in the SPF/RSPF. It is
• Special originals such as transparency film should not be fed through
• Image loss (max. 4 mm) can occur at the leading and trailing edges of
• To stop continuous copying using the SPF/RSPF, press the clear
• Copying using one-sided to one-sided mode (AL-1555) :
1
Make sure that no original is left on the original table.
2
Adjust the original guides to the size
of originals.
3
Set the originals face up in the
original feeder tray.
48
2
to 90g/m
any staples or paper clips from them.
sure to flatten them. If not, original misfeeds may result.
this indicator does not light up, the originals are not properly set or the
SPF/RSPF is not properly closed.
recommended that such originals be copied from the original table.
the SPF/RSPF, but should be placed directly on the original table.
the copies. Also image loss (max. 4.5 mm in total) can occur along the
other edges of the copies. It can be 6 mm (max.) at the trailing edge of
the second copy of two-sided copying.
( ) key.
Ensure that no indicator is lit among the original to copy indicators.
2
.
) indicator on the operation panel will light up. If
Original face up