Installing Internal Options To 3.5-Inch Expansion Bays - Fujitsu 5000 Series User Manual

Installing internal options to 3.5-inch expansion bays

This section explains how to install 3.5-inch expansion bay options such as a 3.5-inch internal
hard disk, magneto-optic disk drive, and 3.5-inch floppy disk drive. A magneto-optic disk drive
is used below in an installation example.
1
Set the internal option.
See the manual accompanying the internal
options to set the following items.
- To install an IDE-standard internal option:
Set the master, slave, and cable selection.
- To install a SCSI interface internal option:
Set the SCSI ID.
2
If retaining metal brackets are mounted on
both sides of the internal hard disk to be
installed, remove them.
Remove the screws (four) to remove the
retaining metal brackets.
3
Remove the upper cover.
4
Remove the front panel.
The front panel does not need to be removed
when installing a hard disk.
5
Remove the blank panel.
Remove the screw (one) to remove the blank
panel.
The blank panel does not need to be removed
when installing a hard disk.
37