Troubleshooting Information On Windows 98 - Fujitsu 5000 Series User Manual

The power is not turned on or the Power lamp on the front panel
does not light up.
Is the power cable plugged in?
Data cannot be read from the CD-ROM drive.
Check the following:
- Has the CD-ROM been placed properly at the center of the tray? Place the CD-ROM on the tray
again with the label side facing upward.
- Has the CD-ROM been placed upside down on the tray? Place the CD-ROM on the tray in the
proper manner with the label side facing upward.
- Is the CD-ROM dirty or wet? Clean the CD-ROM with a soft dry cloth (moving from the center to
the periphery).
- Is the CD-ROM damaged? Replace the CD-ROM.
- Does the CD-ROM conform to the required standard? Use a correct CD-ROM.
Characters entered using the keyboard are not displayed.
Is the keyboard connected correctly? See page 2, "Installation" to connect the display cable
correctly.
The mouse cursor does not move.
Is the mouse connected correctly? See page 2, "Installation" to connect the display cable correctly.

Troubleshooting information on Windows 98

The entire Windows 98 programs are frozen during the execution of an appli-
cation.
First press the Ctrl + alt + Delete keys to end the application. If the application cannot be terminated,
press the Ctrl + Alt + Delete key twice to reboot the computer. If the computer cannot be rebooted,
press the Power switch to turn off the power, then reboot a few minutes later. After the computer
is rebooted, from the Start menu, select Program - Accessories - System tools, then click on Scan
disk.
If no error is detected by the scan disk utility, continue operation. If an error is detected, respond
in accordance with the messages displayed.However, the error might happen again after it has
been corrected. If the error recurs, attempt to reinstall Windows 98 or applications.
Point
The current operation data by an application is not saved if the application is terminated using
the Ctrl + Alt + Delete keys or the computer is reset.
51