Security Group Tree; The Volume Security Window - HP STORAGEWORKS XP24000 User Manual

Figure 4 The Volume Security Window
Item

Security Group tree

Hosts table
CU list
LDEVs table
Apply
Cancel
Security Group Tree
Figure 5 shows the Security Group tree where you can select the LDKC (logical disk controller), and
then choose a security group, host group, or LDEV group residing on that LDKC.
When you double-click LDKC:00 or LDKC:01, you can display a list of security groups, host groups,
and LDEV groups in that LDKC. Once you have selected the LDCK you can choose from these options:
16 Using the Volume Security GUI
Description
Displays the security, host, and LDEV groups assigned to each LDKC defined on the
storage system. For details see
Displays the type, model, SEQNUMBER, Logical Partition (LPAR) and vendor of each
host. For details, see "Hosts
Allows you to select the desired command unit(s) available in each group. When you
select a CU image, the table below shows a list of volumes in the selected CU image
Shows the LDEV, emulation, and attribute information assigned to each logical device
on the storage system. For details, see
Applies the requested XRC setting changes to the storage system. Any change made to
a volume appears in blue italics until you click Apply.
Discards the requested changes without applying them to the storage system. A confirm-
ation message appears to allow you to cancel the requested operation(s). Click OK on
the confirmation message to cancel the requested operation(s), or click Cancel to keep
(but not start) the requested operation(s).
"Security Group Tree " on page 16.
Table" on page 18.
"LDEVs Table " on page 19.