Unpacking And Inspecting The Avs 3120; Installing Your Avs 3120 - Cisco AVS 3120 Hardware Installation Manual

Unpacking and Inspecting the AVS 3120

Unpacking and Inspecting the AVS 3120
The AVS 3120 shipment contains the following items:
•
•
•
•
•
•
•
•
The AVS 3120 is shipped in a protective shipping carton. It is shipped as a self-contained chassis; no
components can be added or removed.
Follow these steps to unpack the AVS 3120:
1.
2.
3.
If the Product is Damaged
If any portion of the unit or component is damaged in transit, forward an immediate request to the
delivering carrier to perform an inspection of the product and to prepare a damage report. Save the
container and all packing materials until the contents are verified.
Concurrently, report the nature and extent of the damage to Customer Service. Report the problem or
deficiency to Customer Service along with the model number and serial number. Upon receipt of this
information, you will be provided with service instructions, or a Return Material Authorization (RMA)
number and shipping information. To obtain assistance, refer to the
on page

Installing Your AVS 3120

Place the AVS 3120 in the desired location. You can mount it in a rack for your convenience, or place it
on a solid, stable surface. If you do not plan to install the AVS 3120 in an equipment rack, proceed to
the
Racks are marked in vertical increments of 1.75 inches (4.45 cm). Each increment is referred to as a rack
unit (RU). A 1-RU device is 1.75 inches (4.45 cm) tall.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Cisco AVS 3120 Application Velocity System Hardware Installation Guide
3-2
One RJ-45 to female 25-pin sub-d connector
One RJ-45 to female 9-pin sub-d connector
One RJ-45 console cable
Two 6-ft Ethernet cables
One rack mounting kit—two metal brackets and screws
Four rubber feet
Cisco Product Documentation CD-ROM and Warranty Package
Cisco AVS 3120 Application Velocity System Hardware Installation Guide
Remove the AVS 3120 accessories from the shipping carton. Save the packing materials in case you
need to repack the AVS 3120 later.
Check the configuration of the AVS 3120 and the accessories against the items listed on the packing
slip. Report any discrepancies as described in
Before installing the AVS 3120, review the information outlined in
Installation."
xiv.
"Installing the AVS 3120 on a Workbench or Tabletop" section on page
Chapter 3
"If the Product is Damaged".
Chapter 2, "Preparing for
"Obtaining Documentation" section
3-5.
Installing the AVS 3120
OL-11805-01