Table of Contents
Advertisement
Removing or Replacing an AVS 3120
Removing or Replacing an AVS 3120
Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Warning
Statement 1
Ultimate disposal of this product should be handled according to all national laws and regulations.
Warning
Statement 1040
To physically remove an AVS 3120 from your network follow these steps:
1.
2.
3.
4.
To physically replace an AVS 3120, install the new AVS 3120 and configure it using the same
configuration parameters (such as the IP address) that you used for the removed AVS 3120. Refer to the
Cisco Application Velocity System User Guide for configuration details.
Cisco AVS 3120 Application Velocity System Hardware Installation Guide
3-14
Login to the shell as the root user and execute the poweroff command. To do this:
Access the CLI and open the shell by using the sysopen command:
a.
velocity>sysopen
b.
Change to the root user using the su command with the dash option:
bash-2.05b$ su - root
c.
Enter the root password (the default is FineGr0und5!):
password:
d.
Execute the poweroff command:
-sh-2.05b# /sbin/poweroff
Power down the AVS 3120 by turning off the power switch on the rear panel of the AVS 3120.
Disconnect the power cords and network cables.
Physically remove the chassis from the rack.
Chapter 3
Installing the AVS 3120
OL-11805-01
Advertisement
Table of Contents
