Rsp Installation - Cisco ASR 903 Hardware Installation Manual

RSP Installation

Pull the fan tray backward toward you no more than 1 inch to disengage it from the power receptacle on
Step 3
the midplane, as shown in
Figure 3-13
TOD
Warning
Step 4 Wait at least 5 seconds to allow the fans to stop spinning. Then, pull the fan tray backward toward you
and out of the chassis.
Note
This completes the steps for removing the fan tray from the chassis.
To install the new fan tray, follow the steps in
RSP Installation
Follow these steps on handling an RSP module in the Cisco ASR 903 Router:
•
•
•
Cisco ASR 903 Router Hardware Installation Guide
3-10
Figure
Fan Tray Removal
SYNC
ACT
PWR
BITS MGMT STAT
ENET
24V—60V 28A
When removing the fan tray, keep your hands and fingers away from the spinning fan
blades. Let the fan blades completely stop before you remove the fan tray. Statement 258
As the fan tray slides out of the chassis, support the bottom of the fan tray with one hand and
keep your other hand on the fan tray handle.
Installing an RSP Module, page 3-11
Removing an RSP Module, page 3-12
Hot-Swapping an RSP Module, page 3-13
3-13.
FAN TEMP
CRIT MAJ MIN
ALARM
"Installing the Fan Tray" section on page
Chapter 3 Installing the Cisco ASR 903 Router
3-8.
OL-25178-04