Rinnai Continuous Flow Water Heaters Operation Manual page 20

Bathroom Deluxe controller
Using shower
Press the 'Shower Saver/Bath Fill' button once. The button will illuminate
saver/bath fill
and a voice prompt and tone will sound. During 'Shower Saver/Bath Fill'
operations the 'Bath' indicator will also be displayed on the Kitchen Deluxe
Controller digital monitor (when fitted).
The voice prompt will say "The hot water system is ready. Open the hot
water tap". Open the hot water tap for the shower or bath.
The 'In Use' indicator will illuminate on all deluxe water controllers and the
shower will run or the bath will start to fill.
To stop shower
If you wish to stop the water flow while the shower saver/bath fill function
saver/bath fill
is in operation, press the 'Shower Saver/Bath Fill' button. The button will
operations
flash and the voice prompt will say "Hot water is not available. Turn off all
hot water taps and push the 'Bath Fill' button". Follow the voice prompt
instructions.
When the
Once the shower saver/bath fill operation finishes, the following occurs:
shower
saver/bath
1. Flow from the shower/bath hot water tap stops.
fill operation
2. 'Shower Saver/Bath Fill' button will flash.
finishes
3. Kitchen Deluxe Controller (if fitted) 'Bath' indicator will flash.
4. A tone will sound.
5. The voice prompt will say "Bath fill is complete. Turn off the bath hot
Follow the voice prompt instructions. Note, the water heater will not allow
hot water to flow from any fixture until the 'Shower Saver/Bath Fill' button
has been pressed.
Using multiple
The water heater can be turned on and off at any water controller. If more
controllers
than one controller is fitted, press the 'Transfer' button to transfer priority
to the desired water controller.
Rinnai New Zealand Ltd
water tap and push the 'Bath Fill' button.
Continuous Flow Water Heater Operation Manual
20
03-11