Rinnai Continuous Flow Water Heaters Operation Manual page 18

Bathroom Deluxe controller
Setting the The clock is a 12 hour AM/PM display. To set the time press the 'Clock'
clock button once. In the digital monitor the clock digits will flash, if this is the
first time the clock has been set the starting time will be AM 12:00.
Use the up and down buttons to select the desired time. Holding these
buttons down continuously cycles the digits. When you get close to the time
you wish to set, press the button intermittently to avoid going further than
the desired time.
To return to normal mode, press the 'Clock' button once. If no buttons are
pressed for approximately 60 seconds the controller will return to normal
mode.
The time is always displayed regardless of whether the controller is turned
On or Off. The clock may need resetting if power to the water heater is
disrupted due to a power failure or if the power is switched off over a
prolonged period.
Setting the To set the sound options press the 'Sound Volume' button and select the
sound options desired audible setting as follows:
• Voice High, Med, Low or off, sets the voice prompt volume but does not
• Sound Off, mutes all voice prompts and audible tones.
Press the up and down buttons to return to normal mode. If no buttons are
pressed for approximately 10 seconds the controller will return to normal
mode.
Adjusting Press the 'Temperature' up and down buttons until the required temperature
temperature is displayed.
Once the hot water is running, if the set temperature is too hot or cold,
press the 'Temperature' up and down buttons until the desired temperature
is reached.
With the water running the temperature can be adjusted down as desired,
but as a safety feature can only be adjusted up as far as 43 °C. To increase
the temperature above 43 °C, first stop the water flow.
Rinnai New Zealand Ltd
affect the 'beep' sound when pressing the buttons
Continuous Flow Water Heater Operation Manual
18
03-11