Charging; Calling; Turning On/Off; Product View - Sony Ericsson HBH-PV715 User Manual

Bluetooth™ Headsets HBH-PV715 and 2
HBH-PV720
Brugervejledning
User guide
Sony Ericsson HBH-PV715 and HBH-PV720
This User guide is published by Sony Ericsson Mobile
Communications AB, without any warranty. Improvements and
changes to this User guide necessitated by typographical errors,
inaccuracies of current information, or improvements to programs
and/or equipment, may be made by Sony Ericsson Mobile
Communications AB at any time and without notice. Such changes
will, however, be incorporated into new editions of this User guide.
All rights reserved.
©Sony Ericsson Mobile Communications AB, 2008
Publication number: 1216-7754.2
Some of the services in this User guide are not supported by all
networks. This also applies to the GSM International Emergency
Number 112. Contact your network operator or service provider
if you are in doubt whether you can use a particular service.
The Bluetooth word mark and logos are owned by the Bluetooth SIG,
Inc. and any use of such marks by Sony Ericsson is under license.
Sony and WALKMAN are trademarks or registered trademarks of
Sony Corporation.
Ericsson is a trademark or registered trademark of Telefonaktiebolaget
LM Ericsson.
This product is leadfree and halogenfree.
1 3
Microphone
Volume keys
Indicator light
On/off key
Call handling
CLA-61
key
Earspeaker
CST-61/CST-18
Call handling key
Volume keys
4
1
2
3
Sony Ericsson Mobile Communications AB
SE-221 88 Lund, Sweden
1216-7754.2
Printed in XXXXX
5
1 2
3 4
xxx xxx xx
1 2 3
xxx xxx xx
6
CST-60/CST-70
CDS-60
This is the Internet version of the User guide. © Print only for private use.
English To answer a call
• Press the call handling key briefly.
The Bluetooth™ headsets HBH-PV715 and HBH-PV720
can be connected to any device with Bluetooth wireless To reject a call
technology that supports the handsfree or headset
• Press and hold down the call handling key until you
profile. This User guide focuses on use with
hear a short beep (after 2 seconds).
a Sony Ericsson mobile phone.
To redial the last number
Charging the headset
• Double-click the call handling key.
Before using the HBH-PV715 or the HBH-PV720 for
the first time, you must charge it with, for example, the To answer a second call
supplied charger or your phone charger, see figure 2.
• Press the call handling key. The ongoing call is put
For compatible chargers, see figure 3. on hold.
Turning on and off the headset To switch between two calls
• Press and hold down the call handling key until you
To turn on the headset
hear a beep.
• Press and hold down the on/off key until the indicator
light shows a steady green light (if the light is red, the
To turn off the microphone (mute)
headset needs charging). After 3 seconds, the light
• Press both volume keys simultaneously. Mute is
turns off and the headset stays on.
indicated with a beeping sound. Repeat to turn
on the microphone again.
To turn off the headset
• Press and hold down the on/off key until the
Adjusting volume
indicator light shows a steady green light (if the
light is red, the headset needs charging). After 2 To adjust the ring volume
seconds, the light fades and the headset turns off. • When you are not making a call, or when the phone
is ringing, press a volume key.
Pairing the headset
To adjust the speaker volume
Before you can use the headset it has to be paired
once with your phone. After a successful pairing, the • During a call, press a volume key.
headset connects automatically to the phone when
Calling using voice commands
it is turned on and within range.
Voice commands can be useful when you are using
Bemærk: When you put the headset in pairing mode, the headset and the phone is not close to you.
do not press the call handling key together with the
For more information on voice commands, see your
on/off key. phone User guide.
To pair the headset with your phone To make a call using voice commands
1. Turn on the Bluetooth function in the phone. • Press the call handling key briefly, wait for a beep
For instructions, see the phone User guide.
and say your command.
2. Place the phone within 20 cm (8 inches) of the headset.
3. Turn on the headset. The first time you do so,
Bemærk: Make sure voice commands are enabled
the headset enters pairing mode automatically and recorded in your phone before you use them.
and tries to pair with your phone (auto pairing).
Transferring sound
Bemærk: If auto pairing is not supported by your phone,
To transfer sound from the phone to the headset
or not successful, follow the two first steps above
• During a call, press the call handling key briefly.
and turn on the headset. Then add the headset to
The sound is transferred to the headset.
your phone as described in your phone User guide.
The passcode is 0000.
To transfer sound from the headset to the phone
• See the phone User guide.
To pair the headset with another phone
1. Turn on the Bluetooth function in the phone.
Battery
For instructions, see the phone User guide.
A new, or infrequently used, battery could have
2. Place the phone within 20 cm (8 inches) of the headset.
reduced capacity. It may need to be recharged
3. Turn off the headset if it is turned on. Press and hold
a few times to reach full capacity.
down the on/off key until the indicator light flashes
When the battery needs charging, the indicator
red and green alternately.
light flashes red and you hear a low beep. If you
4. Press Yes when Add device? appears in the phone.
do not charge the headset, it turns off automatically.
If required, the passcode is 0000. The headset
beeps and flashes green when paired successfully.
To check the battery status
Putting on the headset • Press the on/off key briefly:
• steady green light plus one green flash –
Slide the ear hook behind your ear and point the
the battery needs charging soon
microphone towards your mouth. For left ear use,
• steady green light plus two green flashes –
change the position of the ear hook as instructed
the battery is half full
in figure 4.
• steady green light plus three green flashes –
the battery is fully charged

Calling

When you have paired the headset with your phone,
Resetting the headset
you can make and receive calls as long as the headset
To reset the headset
is turned on.
1. Turn off the headset.
Solid objects, walls and a greater distance than
2. Press and hold down the on/off key until the
5 metres (16.5 feet) can affect the sound quality
indicator light flashes red and green alternately.
negatively. For best performance, you should wear the
3. Press and hold down the on/off key and the call
headset and the phone on the same side of your body.
handling key simultaneously until the headset
turns off.
To make a call
4. Pair the headset with the phone in the same way
• Use the phone keys to dial the number as normal.
as you paired it the first time.
The call is activated automatically in the headset.
To end a call
• Press the call handling key briefly.