Air Shutter Setting; Media Options; Verify Performance Of Appliance - Heat & Glo XLR-N-AU Owner's Manual

G. Air Shutter Setting
Air shutter settings may be adjusted by a qualified install-
er at the time of installation. The air shutter is set at the
factory for minimum vertical vent run. Adjust air shutter for
longer vertical runs. See Figure 14.2.
• Loosen the 1/4 in. (6 mm) screw.
• Twist shutter to adjust
• Shutter may be open for longer horizontal vent runs.
• Do not close the air shutter more than 5/8 in. (16 mm)
for NG or 3-1/8 in. (80 mm) for LP. Note: the air shutter
should be fully open when using butane.
• Tighten the screw.
NOTICE: If the flames appear to be orange, open the air
shutter to prevent residue buildup on the glass.
Figure 14.2 Air Shutter
Shutter Settings - Glass Media and Media-Stones-2
USA/Canada
NG 1/16 in.
LP (Propane) 5/16 in.
Butane* N/A
*Butane gas is only approved for use in Europe, Australia,
and New Zealand
Shutter Settings - XLR Logs
USA/Canada
NG 3/16 in.
LP (Propane) 7/16 in.
Butane* N/A
*Butane gas is only approved for use in Europe, Australia,
and New Zealand
54
Europe AU NZ
.2 cm 2 mm 2 mm
.8 cm 8 mm 8 mm
Full Open Full Open Full Open
Europe AU NZ
.5 cm 5 mm 7 mm
1.1 cm 11 mm 11 mm
Full Open Full Open Full Open
Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. M • 5/12
H. Media Options
Unit ships without a media option. Available approved
media options are:
• MEDIA-AMBER
• MEDIA-BLACK
• MEDIA-CLEAR
• MEDIA-COBALT
• MEDIA-BK2-GEMS
• MEDIA-WH2-GEMS
• MEDIA-GEMS
• PORC-BASE
• XLR-LOGS
• MEDIA-STONES-2
I. Verify Performance of Appliance
1. Verify pilot sparks, pilot lights, pilot stops sparking, and
the main burner turns "ON" by turning wall control "ON".
2. Turn fireplace OFF. Verify that the both the pilot and
burner turn "OFF".
3. Repeat Step 1 above.
4. With the burner "ON" remove the green wire connected
to the gas valve after the second audible "beep" from
the control module is heard. The main burner should
shut off. Turn appliance "OFF".
5. Reattach the green wire to the valve and turn ON the
fireplace. The main burner should light after the second
audible "beep" from the control module is heard.
6. With the main burner ON, remove the green wire con-
nected to the gas valve after the second audible "beep"
from the control module is heard. The main burner
should shut off.
7. Turn fireplace "OFF" and reattach orange wire to the
valve.