D. Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105 °C rated wire. Wire must have high temperature
insulation.
Heat & Glo • XLR-N-AU, XLR-PB-AU • 2198-906 Rev. M • 5/12
E. Junction Cord Information
The junction cord is installed at the factory. refer to figure
12.2. for more information.
Note: There is an alternative access to the junction cord.
This can be accessed by removing the valve assembly. See
Figures 11.1 and 11.2.
Figure 12.2. Junction Cord Information
45