NAILING TABS
(BOTH SIDES)
Figure 7.3 Proper Positioning, Leveling and Securing of a
Appliance
WARNING
Fire Risk.
• ALWAYS maintain specifi ed
clearances around the appliance.
• Do NOT notch into the framing around the appliance spacers.
Failure to keep insulation, framing or other material away from
the appliance may cause fi re.
D. Completing Grate Set-up
1. Straighten the tabs on the grate bracket (see Figure
7.4) and remove grate from unit.
2. Remove grate bracket (see Figure 7.4) by bending it
back and forth until it breaks. Discard grate bracket.
3. Remove 4 tabs holding base refractory (see Figure 7.4)
by bending tabs back and forth until they break.
REMOVE GRATE
REMOVE GRATE BRACKET
REMOVE TAB HOLDING DOWN
BASE REFRACTORY (4 PLACES)
Figure 7.4 Removing Grate
Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08
4. Reinstall grate into unit (see Figure 7.5).
E. Checking Pilot Plate
Note: Ensure pilot plate is in place. This will ensure pilot
stability (see Figure 7.6)
STRAIGHTEN TO
REMOVE GRATE
RE-INSTALL
INTO THE UNIT
Figure 7.5 Re-install grate in unit
Figure 7.6
PILOT
PLATE
17