Using The Default Management Address - Paradyne 8411-A1-000 Installation Instructions Manual

Using the Default Management Address

The SCP card uses Transaction Language 1 (TL1) language for Command Line
Interface (CLI) commands and messages. The CLI can be used to configure and
maintain the system, but the web interface is recommended. You can access the
web interface using the default management address or a network address you
specify using the CLI (see
Procedure
To use the default management address:
8400-A2-GZ40-10
1. Connect a PC to the Ethernet port of the SCP card using a crossover cable.
2. Access the web interface by typing the default address 10.10.10.10 into the
Location field of your web browser. See
October 2003
Setting the Management Address Using the
Using the Web Interface
CLI).
on page 11.
9