Advertisement
To align scoring blade:
Loosen the clamping screw (A). Lateral adjustment is
made via adjusting screw (B). the height setting is made
via setting screw (C). retighten the clamping screw (A).
Adjust the scoring blade laterally so it is in line with the
main saw-blade.
Replace and adjust the riving knives
Disconnect the saw from the power source!
1. Move the blade tilt to 0˚ (Blade 90˚ to table) on the
control panel and raise the blade as far as it will go.
2. Move the sliding panel all the way to the right and
remove two M6x12 pan head screws to expose the
internal blade guard that covers the blades and
riving knife.
3. Remove the blade guard from the riving knife to
expose the mounting assembly.
4. Remove the center bolt in the mounting assembly
to remove the mounting plate.
5. Remove the currently installed riving knife and
install the correct riving knife.
6. Replace the mounting plate and thread in the
center bolt without completely tightening it.
The riving knife is carved with different blade size,
just put the carved line under table.
The center carriage bolt is mounted in a horizontal
slot, so the riving knife can move far or near the
main blade.
7. Position the riving knife about 3mm to 8mm away
from the nearest carbide tooth on the main blade.
Note For a quick gauge, use the 3mm hex wrench
to find the correct spacing between the blade and
the riving knife.
8. Tighten the center bolt to secure the riving knife in
position.
9. Move the internal blade guard (from step 4) back to
its original position, and move the sliding panel
back to center.
Replace the main belt
Disconnect the saw from the power source!
1. Move the blade tilt to 0˚ (Blade 90˚ to table) on the
control panel and raise the blade as far as it will go.
2 . Move the sliding panel all the way to the left and
remove two M6x12 pan head screws to expose the
internal blade guard that covers the blades and
riving knife.
3 . Remove the blade guard from the riving knife to
expose the mounting assembly.
4 . Remove the main blade.
5 . Remove 3 M8x18 Allen screw and remove the chip
house.
Note To remove lower 2-M8x18 Allen screws, the
main blade angle system tilt to 30˚, to remove the
upper 1-M8x18 Allen screw , the main blade angle
system tilt to 0˚.
6 . Remove the 4 Allen screws on the top and bottom
of left panel, and remove the left panel.
7 . Loosen motor amount 4-M8x40 hex head
screws(A) and loosen the tension bolt (B).
8 Remove the V-belt.
9 Replace new V-belt, tighten motor bolts and the
tension bolt, close the left panel, and re-mount
blade inner guard, blade, blade guard.
Advertisement
