Advertisement
2 .Place the cross-cut table support (A) onto the swing
arm assembly, and hand tighten the lock nuts. The
support needs further adjustment.
Install the Sliding panel assembly
1 .Place 2 sets of star-type screws (include 8mm
washer, insert, screw guide) into the lower slot of
sliding panel carrier ( see above 14).
2.Put the sliding panel assembly onto the sliding panel
supports, and lay two star-type screws as fig 15 show.
3.Tighten two star-type screws.
4. Install the support leg to the sliding carrier.
Adjust the sliding panel level:
1 . Place a level rule (cross cut fence) on to major table
and sliding panel.
2.Loosen 4-M8x25 hex screws(A) , adjust the M8x40
hex screw(B) to adjust the sliding panel level(fig 13).
3.Then re-tighten 4-M8x25 hex screws (A).
4.To fine adjust, using 3 mm "L" wrench to adjust 4-
M8x12 set screws(C).
Install the push handle and lock pin
1 . Sliding the M12x1.75 T-nut into the sliding panel and
thread in push handle(D) with a 17 mm open end
wrench.
2. Insert the star-type lock pin (E) into sliding panel, and
lock the M10 hex nut on the opposite side.
Install the cross cut table
1.Slide two M8x70 carriage bolts with T-lblocks into the
side slot of sliding panel. Attached the crosscut table
to sliding panel.
2.Use 2 wing nuts mounted the cross cut table to sliding
panel.
3 .Use 2 M6x30 Hex head scews mounted the cross cut
table to support (B).
4 .Adjust 4-M12 thin hex nut (C) to adjust the cross cut
table on the line with sliding panel.
5.Then tighten 4-M12 thin nut (C).
Advertisement
