Table of Contents
Advertisement
6.8 Frequency/Voltage Control
Auto Detect PCI CIK
Setup auto detect PCI clock
CPU Clock
Setup CPU BUS frequency
Note: The main board auto detect CPU frequency 'so you needn't setup CPU frequency
by yourself the CPU can display normal.
6.9 Load Fail-Safe Defaults
If you select this item and press enter a dialog box appears. If you press Y, and
then Enter, the setup utility loads a set of fail-safe default values. These default values are
not very demanding and they should allow your system to function with most kinds of
hardware and memory chips.
Note: It is highly recommended that uses enter this Option to load optimal values for
accessing the best performance.
6.10 Load Optimized Defaults
If you select this item and press enter a dialog box appears. If you press, Y, and
then Enter, the setup utility loads a set of best performance default values. These default
values are quite demanding and your system might not function properly if you are using
slower memory chips or other low-performance components.
6.11 Change Password
If you highlight this item and press Enter, a dialog box appears that you can enter
a supervisor password. You can enter no more than six letters or numbers. Press enter
after you have typed in the password. There will be the second dialog box asking you to
retype the password for confirmation. Press Enter after you have retyped it correctly.
Then the password is required for the access to the setup utility or for it at start-up,
depending on the setting of the password check item in advanced setup.
6.12 Save Exit & Without Save Exit Setup
Highlight this item and press enter to save the changes that you have made in the
setup utility configuration and exit the program. When the save and exit dialog box
appears, press Y to save and exit, or press N to exit without saving.
Default: Enabled
Hide quick links:
Advertisement
Table of Contents
