KTI Networks KGS-612F User Manual page 27

Configuration
MAC Address
S/W Version
H/W Version
Active IP Address
Active Subnet Mask
Active Gateway
DHCP Server
Lease Time Left
DHCP Enabled
Fallback IP Address
Fallback Subnet Mask
Fallback Gateway
WDT
Management VLAN
- VID
- CFI
- User priority
Name *
Password
SNMP enabled
SNMP Trap destination The IP address of the SNMP trap manager
SNMP Read community The community allowed for the SNMP [get] message
SNMP Write community The community allowed for the SNMP [set] message
SNMP Trap community The community used for the SNMP trap messages sent by the switch
[Apply]
[Refresh]
Note:
1. It is suggested to give each switch unit a system name as an alternative unique identifica-
tion beside IP address.
2. Setting change of DHCP mode takes effective in next bootup.
3. A watch dog timer (WDT) is a hardware timing device that triggers a system reset if the
system firmware, due to some fault condition, such as a hang, neglects to regularly service
the watch dog timer . The intention is to bring the system back from the hung state into
normal operation. The timer is set to 1.72 seconds in this switch.
Description
The MAC address factory configured for the switch
It can not be changed in any cases.
The firmware version currently running
The hardware version currently operating
Currently used IP address for the switch management
Currently used subnet mask for IP address for the switch management
Currently used gateway IP address for the switch management
Current IP address of the DHCP server
The time left for the lease IP address currently used
Use DHCP to get dynamic IP address configuration for the switch
IP address used when DHCP mode is not enabled
Subnet mask for IP address used when DHCP mode is not enabled
Default gateway IP address used when DHCP mode is not enabled
Enable WDT (Watch Dog Timer)
Set management VLAN information
VLAN ID configured for web management to the switch
CFI value for web reply packets from the switch
Priority value for web reply packets from the switch
Set the system name for this switch unit
Set new password
Enable SNMP agent
Click to apply the configuration change
Click to refresh current configuration
-27-