Technical Information - Zanussi ZWF 1225 User Manual

Problem
The appliance fills with water
and drain immediately.
The washing results are not
satisfactory.
After the check, activate the appliance. The
programme continues from the point of inter-
ruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes. Deacti-
vate and activate the appliance. If the problem
continues, contact the Service.

Technical information

Dimensions
Electrical connection:
Level of protection against ingress of solid particles and moisture en-
sured by the protective cover, except where the low voltage equip-
ment has no protection against moisture
Water supply pressure
1)
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
www.zanussi.com
Make sure that the packaging and/or the transit bolts are removed. Refer to
'Installation'.
Add more laundry in the drum. The load may be too small.
Make sure that the drain hose is in the correct position. The hose may be
too low.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you wash the
laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum
Possible solution
Service
We recommend the use of original spare parts.
When contacting the Service, make sure that
these data are available. You can find the infor-
mation on the rating plate: model (Mod.), PNC
(Prod.No.), Serial number (Ser.No.).
600 / 850 / 600 mm
640 mm
220-230 V
2000 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
8 kg
1200 rpm (ZWF 1225)
1400 rpm (ZWF 1425)
19