Troubleshooting - Zanussi ZWF 1225 User Manual

6.
7.
2
8.
Emergency drain
Because of a malfunction, the appliance cannot
drain the water.

Troubleshooting

The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer
to the table). If not, contact the service centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with water.
•
- The appliance does not drain the wa-
ter.
www.zanussi.com
1
If this occurs, do steps (1) through (8) of 'To
clean the drain pump'.
If necessary, clean the pump.
When you drain the water with the emergency
drain procedure, you must activate again the
drain system:
1. Put 2 litres of water in the main wash com-
partment of the detergent dispenser.
2. Start the programme to drain the water.
Frost precautions
If the appliance is installed in an area where the
temperature can be less than 0 °C, remove the
remaining water from the inlet hose and the
drain pump.
1. Disconnect the mains plug from the mains
socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a con-
tainer and let the water flow out of the
hose.
5. Empty the drain pump. Refer to the emer-
gency drain procedure
6. When the drain pump is empty, install the
inlet hose again.
Warning! Make sure that the temperature
is more than 0 °C before you use the
appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
•
- The appliance door is open or not
closed correctly. Please check the door!
•
- The mains supply is unstable. Wait
until the mains supply is stable.
Warning! Deactivate the appliance before
you do the checks.
17