Installing Batteries; Millennium; Programming Tv Control; Setup Codes For Tvs - Universal Electronics MILLENNIUM 4 User Manual

INSTALLING BATTERIES

1. On the back of the Millennium 4, push the tab
and lift off the battery cover.
2. Obtain two (2) fully charged AA alkaline
batteries.
Match the + and – marks on the batteries to the +
and – marks in the battery case, then insert the
new batteries.
3. Press the battery cover back into place. The
tab should click when the cover is locked.
4. Test the unit by pressing POWER and any
mode key (e.g. AUDIO, VCR, TV, or CBL). If
the batteries are inserted correctly, the LED will
blink once.
NOTE: Whenever batteries need replacement, the
Millennium 4 will blink twice with every key press.
Simply replace the batteries and the Millennium 4 will
be restored to its full functionality, complete with your
favorite settings.
7

PROGRAMMING TV CONTROL

NOTE: If you own a TV/VCR combination, skip this
section and perform "Programming TV/VCR Combo
Control" on page 16.
Locate the brand name of your TV in the Setup
Codes For TVs section below, and write it in the
following space.
TV Brand:
__________________________________
The brands are listed in alphabetical order with
the most popular codes listed first. You will use
one of these codes to program the Millennium 4
to operate your TV:
1. Turn on the TV.
2. On the Millennium 4, press TV once. Press
and hold SETUP until the LED blinks twice,
then release SETUP.
3. Enter the first four-digit code for your TV. If
you perform this procedure correctly, the LED
will blink twice.
NOTE: If the LED did not blink twice after entering
the code's last digit, then repeat steps 2 through 3 and
try entering the same code again.
4. Aim the Millennium 4 at your TV and press
POWER once. The TV should turn off. If it
does not respond, repeat steps 2-3, trying each
code for your brand until you find one that
works. If it still does not work, try searching for
the code (see Searching For Your Code on page
26).
5. Write your TV code in the boxes below for
future reference.
NOTE: Remember, to use the Millennium 4 to operate
your TV, press TV first.

Setup Codes for TVs:

A-Mark 0003
AOC 0030, 0019, 0003, 0052, 0185
Abex 0032
Admiral 0093
Adventura 0046
Aiko 0092
Akai 0030
Alaron 0179
Ambassador 0177
8
continued on next page...