Table of Contents
Advertisement
To check
STOP
TIME:
Hold in STOP TIME button until the words STOP TIME
appear in the Display Window. The stop time will be displayed briefly, then Display will
return to on-going program.
To change
STOP TIME
before
cleaning
begins:
1.
Hold in STOP TIME button until words STOP TIME appear in the Display Window.
2.
Turn SET dial to desired STOP TIME.
3.
Push ENTER button to enter new stop time.
NOTE: If more than 7 seconds elapse between holding in START TIME button or
STOP TIME button and turning the SET dial, the display window will automatically
return to on-going program.
NOTE: If more than I minute elapses between turning SET dial to a new time and
entering new START TIME andSTOP TIME, the entire program will be cancelled
and display will return to time of day clock.
To stop cleaning
process
before
lock
indicator
light
comes
on:
1.
Move the DOOR LOCK LEVER to the left.
2.
Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.
3.
Push CANCEL button twice.
To stop
cleaning
process
after
lock indicator
light
comes
on:
1.
Push CANCEL button twice.
2.
Leave the TEMPERATURE and SELECTOR knobs in the CLEAN position.
3.
Allow oven to cool until the LOCK INDICATOR LIGHT goes out. This may take up
to 45 minutes, depending on how long the oven has been on.
4.
After LOCK INDICATOR LIGHT goes off, move the DOOR LOCK LEVER to the left.
5.
Turn SELECTOR and TEMPERATURE knobs from CLEAN to OFF.
NOTE: When SELECTOR knob is turned to CLEAN, a fan comes on. If this fan
is not operating, the oven will go through the self-cleaning process at a reduced
oven temperature and the oven will not clean effectively. If the fan does not operate,
contact your Jenn-Air Authorized Service Contractor for service.
35
Advertisement
Table of Contents
