Electrical - Henny Penny BCF-24 Operator's Manual

2-2. UNPACKING
(Continued)

2-3. ELECTRICAL

Electrical Box Location
2-2
The BCF-24 weighs about 250 lbs (112.5 kg), the
BCF-65 about 340 lbs (153 kg), and the BCF/BCM-110
about 364 lbs (165 kg). Care should be taken when
lifting unit to prevent personal injury.
4. Open door and remove packing from racks and the hori-
zontal slides from the inside of the unit.
5. Peel off any protective covering from the exterior of the
cabinet.
6. Install the slides onto the vertical racks.
7. Your blast chiller/freezer is now ready for operation.
The blast chiller/freezer is available as a 208, 230, or 200 VAC, 50
or 60 Hz, single phase unit, both for domestic and international use.
The data plate, located on the left side of the unit, will specify the
correct electrical supply. The BCF-24 and 65 are shipped with a
6 foot, 7 inch (2 m) cord and plug, and requires a grounded
receptacle with a separate electrical line protected by a fuse or
circuit breaker of the proper rating. The NEMA number for the
plug is NEMA 6-20P.
This unit must be adequately and safely grounded.
Refer to local electrical codes for correct grounding
procedures. If unit is not adequately grounded, electri-
cal shock could result.
To avoid electrical shock, this appliance must be
equipped with an external circuit breaker which will
disconnect all ungrounded (unearthed) conductors.
Refer to the table below for electrical ratings:
Model No. Volts
BCF-24 208-240
230
200
BCF-65 208-240
230
200
BCF-110 208-240
and 400
BCM-110 200
Model BCF-24/65/110, BCM-110
Watts Amps Freq. Phase
2300 4.3
1800 9
1800 11
3000 7
2900 13
2500 12
4600 17
3100 9
3800 17
60 1
50 1
50 1
60 1
50 1
50 1
60 3
50 3
50/60 3
1105