Programming - Henny Penny BCF-24 Operator's Manual

3-7. PROGRAMMING

Displayed Step
00
01
02
03
04
3-10
Information about the operation settings can be accessed by
pressing . These settings can also be changed while in the
different steps. The following information can be accessed:
After pressing
number appears in the display, and the number in the left
column shows for 2 seconds. You then only have 12 seconds
to change the setting.
Not Available at this time.
Not Available at this time.
Internal air temperature. Press
digital display shows the air temperature during a Probe Cycle.
Evaporator temperature. Press
display shows the evaporator temperature during the De-icing
Cycle.
Type of program setting indicated by the jumper
link located on the control board. Press
the digital display shows a number between 5 and 9, which
indicates the position of the jumper on the control board. The
control panel area does not have to be accessed to obtain the
information. (See chart at left.) Henny Penny controls should
show a 6 in the display.
Model BCF-24/65/110, BCM-110
, a delay occurs before the desired
three times and the
4 times and the digital
5 times and
605