HP Compaq 8100 Elite Hardware Reference Manual page 21

11. To install a new expansion card, slide the bracket on the end of the card down into the slot on the
back of the chassis and press the card down firmly into the socket on the system board.
Figure 12
NOTE:
seats properly in the expansion card slot.
If auxiliary power is required (on some Z200 Workstation graphics cards), attach the auxiliary
graphics connector to the card after installation in the slot.
12. Close the expansion card retention latch, making sure that it snaps firmly into place.
13. Connect external cables to the installed card, if needed. Connect internal cables to the system
board, if needed.
NOTE:
installation instructions to find the location of the appropriate power cable.
14. Replace the computer access panel.
15. Reconnect the power cord and turn on the computer.
16. Lock any security devices that were disengaged when the computer access panel was removed.
17. Reconfigure the computer, if necessary.
ENWW
Installing an Expansion Card
When installing an expansion card, press firmly on the card so that the whole connector
Some cards (for example, graphics, 1394) require additional power. See the card
Removing or Installing an Expansion Card 15