Mail; Emergency; Output - LG LE5008 Series Owner's Manual

40 Installation
• Sensor On: Sends an e-mail when a sensor has occurred.
• Motion Detection: Sends an e-mail when a motion detection
has occurred.
• Text In: Sends an e-mail when a text input is detected.
• Admin Password Changed: Sends an e-mail when the
administrator password has changed.
• Video Loss: Sends an e-mail when a video signal from the
camera has stopped because of a cable disconnection or
malfunction of a camera.
• Power On/Off: Sends an e-mail when power is on or off.
• Disk Full: Sends an e-mail when the HDD has fully recorded.

Mail

3
• Notification: Marks up to notify the unit operating information
according to notification settings by e-mail.
• SMTP Server: Enter the SMTP Server address.
If notification option is not mark up and the SMTP server option
is empty, the SMTP Port, User Name, Password and TLS options
cannot be set.
• SMTP Port: Enter the SMTP Port Number. Typically the port used
for SMTP is 25. However in some cases it is better to change this
port number for added flexibility or security. You can edit this
port between 1 and 65 535.
• User Name: Enter the user name.
• Password: Enter the password.
• TLS: Marks up when using the TLS (Transport Layer Security)
function.
• Mail Address (1 to 3): Enter the mail address.
You can input up to 3 e-mail addresses.
• E-mail Test: Select [E-mail Test] to test send an e-mail.
NOTE
The SMTP server, SMTP port no., user name or password settings
are optional. The DVR can send e-mail directly without the use of
an SMTP server or MTA (message transfer agent). In certain cases
all e-mail should be forwarded to a specific SMTP server. Specify
the server host name or IP address in such a case. For more detail
on SMTP setup, ask your network administrator and/or mail service
provider.

Emergency

• Notification: Marks up to notify the emergency agent about unit
operating information according to your notification settings.
• Host Name/Port: Enter the Host Name and port number of the
emergency agent program. The factory default port for this
function is 9002. However in some cases it is better to change
this port number for added flexibility or security. You can edit
this port between 1 025 and 65 535.
You can set up to 9 Host Name and port numbers.

Output

• Relay Off
- ALARM ACKNOWLEDGE: Use the ALM.OFF button to stop
alarm.
- POST-ALARM TIME: The alarm is stopped after post-alarm
time.
• System Alarm Out: Outputs the alarm (relay) signal via the
selected alarm out terminal number below cases. If you do not
use this function, select [NONE] option.
- When the HDD has a bad sector.
- When a video signal from the camera has stopped because
of a cable disconnection or malfunction of a camera.