Connecting To A Device; Configuring The Network Settings Of A Device - Honeywell EQUIP Series Installation And Configuration Manual

Connecting to a Device

Configuring the Network Settings of a Device

Document 800-04194V1 Rev A
07/11
®
EQUIP Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
When the Honeywell IP Utility opens, it automatically searches for devices on the
network—including devices on other subnets. Devices that are discovered on
the network are listed in the Discovery panel at the left of the screen.
The list of discovered devices is automatically refreshed at regular intervals. You
can also manually refresh the list by clicking the Refresh button
To connect to a device:
1. In the Discovery panel, click the device you want to connect to.
2. Click the Connect button
Note If you see the Limited/No Connectivity
device is on a different subnet than your client computer. Check the
network settings for both the device and the client computer. Consult
your network administrator for additional support.
After you have connected to a device, you can give it a name and configure its
network settings.
By default, the device name is the device type plus the MAC address (the MAC
address is a factory-assigned identifier that is unique to each device). It is
recommended that you give each device a descriptive name for easy
identification.
To name a device:
• In the Device Name box, type a name for the device (for example,
FrontLobbyDome01), and then click Apply.
By default, network settings are configured automatically for the device by the IP
network's Dynamic Host Configuration Protocol (DHCP) server. You can also
configure the device's network settings manually.
.
button, the discovered
.
27