Dixon 3000 SERIES Operator's Manual page 14

CHASSIS:
BODY:
MOWER DECK:
BLADE DRIVE:
TRANSMISSION:
ENGINE:
STARTING SYSTEM:
TIRES:
RECOMMENDED
TIRE PRESSURE:
CAPACITIES:
DIMENSIONS:
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.
14
SPECIFICATIONS
Model ZTR 3304
Twin 12 gauge side frames and 7 gauge transmission
and engine base plate.
All body parts are made of rotational molded poly-
ethylene. Front body contains access panel for
battery service. Seat tilts forward to allow trans-
mission service.
11 GA stamped steel construction. Single 30" cut
blade. Cut height approximately 1" to 4" via 7 position lift
handle.
Mechanical; hand lever engagement.
Each rear wheel is independently driven by chain and
sprockets through a friction mechanical drive.
13.5 HP Briggs & Stratton Intek,4-Cycle, Single
Cylinder, Overhead Valve, Air-Cooled, Gasoline,
Vertical Shaft, Cast Iron Cylinder, AVS (Anti Vibration
System), Pressure Lube & Filter
Electric by key switch operation with safety interlocks on
parking brake and blade drive.
Front
Rear
Front
Rear
Fuel
Engine
Width
Height
Length
Weight
11 X 4.00-5 ribbed tread.
16 X 6.50-8 Turf Trac R/S tread.
16-21 PSI
8-14 PSI
2.0 gallons total.
1.25 quarts oil.
32.5" outside rear wheel measurement.
32.0" to top edge of seat.
65.5" hitch tab to front bumper.
440 lbs.