Yamaha neoHD WiFi YMC-700 Owner's Manual page 13

Initial Setup
Before proceeding to the next operation
Once you perfonn the next operation, this unit starts the Auto
Speaker Setup procedure in 10 seconds. During the Auto
Speaker Setup procedure, do not perform any operation on
this unit. For more accurate measurements, we recommend
that you get out of the room or move to a wall away from any
speakers in the meantime. It takes a few minutes.
8
Select "Start" to start the measurement.
This unit starts the count down for the measurement.
Loud test tones are output from each speaker during
the measurement. Once all items are measured, the
following screen appears:
Results (example)
If an error message (Q' P. 50) appears
If a warning message (It? P. 50) appears
Warning message (example)
If the warning message "SWFR LEVEL ERROR"
appears, the adjustments are made, but the adjustment
may not be optimal. Select "Next" to continue the
process.
9
Check the status of each speaker, then select
"Save" to proceed with the Initial Setup
process.
The speaker statuses are as follows:
Yes:
Speaker is connected.
No:
Speaker is not installed, or speaker cable
is disconnected.
Too Loud:
Subwoofer (SWFR) only. The level of
the subwoofer is too high.
Too Low:
Subwoofer (SWFR) only. The level of
the subwoofer is too low.
If you are not satisfied with the result, check the
speaker connections and/or subwoofer level, then
select "Retry".
If you want to proceed with the Initial Setup process without
using the result of the measurements, select "Cancel".
Error message (example)
• Solve the problem (- P. 50), then select "Retry" to
retry the measurement.
• Select "Cancel" to cancel the setup process.
12
En
10
Disconnect the YPAO Mic from this unit and
select "OK".
The YPAO Mic is sensitive to heat. Keep it away
from direct sunlight.