Armrest Width - Pride Jazzy 1120 Owner's Manual

V I . C O M F O R T
Once you are familiar with your Jazzy’s operation, you may find the
need to adjust your seating position. There are some adjustments you
can make to increase your comfort, such as seat height and angle,
armrest height and angle, footrest height and angle, and joystick position.
WARNING! If your Jazzy 1120 was configured
at your authorized Pride provider or service cen-
ter, please consult your health care professional
before changing the seat position or making any
other adjustment. Some adjustments may de-
grade your Jazzy’s performance and safety by
changing its center of gravity.
SEAT HEIGHT AND ANGLE
You can change the seat height by one of two ways: either manually
or automatically. (If equipped with the optional Power Elevating Seat,
see “Power Elevating Seat Option” later in this section.)
To change the seat height:
1. Remove the seat. See VII. “Disassembly.”
2. Remove the shroud.
3. Remove the ball detent pin from
each seat tower. See figure 15.
4. Raise or lower each seat tower to the desired position.
5. Install the ball detent pin into each seat tower.
6. Reinstall the shroud.
7. Install the seat.
To change the seat angle:
1. Remove the seat hinge bolts with a 5/32-in. hex key and a
7/16-in. wrench. See figure 16.
2. Adjust seatback to desired angle and reinsert the seat hinge bolts.
3. Tighten bolts with the hex key and wrench.

ARMREST WIDTH

To change the armrest width:
1. Locate the two knobs on the armrest receiver bracket. See fig-
ure 17.
2. Loosen the knobs and slide the armrests in or out to the desired
width.
3. Tighten the knobs.
24 www.pridemobility.com
A D J U S T M E N T S
Figure 16. Seat Angle
Figure 17. Armrest Width
JAM NUT LOCKS
ADJUSTMENT
SCREW IN PLACE
TURN THIS SCREW
TO CHANGE
ARMREST ANGLE
Figure 18. Armrest Angle
SEAT
HINGE
BOLT
LOOSEN KNOB TO
MOVE ARMREST
Jazzy 1120/RevE/Feb03