Assembly - Pride Jazzy 1120 Owner's Manual

To reduce the possibility of shipping damage, your Jazzy 1120’s seat
is removed from the power base, and the seatback is removed from
the seat assembly before your Jazzy is shipped. The joystick may
also have been removed from the armrest. The following is a set of
instructions to help you quickly and easily prepare your Jazzy 1120
for immediate use.
Parts List
Phillips-head seatback mounting screws
Seatback
8-in. wire ties
SEATBACK ASSEMBLY
The seatback mounts to the back hinges with four (4) Phillips-head
screws. You may install the seatback before or after you install the seat to the power base.
To mount the seatback to the hinge:
1. Line up the hinges with the holes in the seatback. See figure 9.
2. Insert the seatback mounting screws through the hinge and
into the seatback.
3. Tighten the four screws.
WARNING ! Do not pick up the seat frame by the
armrests. They are free to pivot, and you may lose
control of the seat if they do so, resulting in
personal injury or damage to the chair.
SEAT INSTALLATION (SEAT WITH H-FRAME)
The standard seat installation method incorporates the seat frame (H-
frame) and four (4) adjustable seatposts located on the power base.
To install the seat:
1. Set the seat on the rear seat towers. See figure 10.
2. Push the seat back and down until the latches engage on the
front seat towers. See figure 11.
3. Plug the controller cable into the connector on the utility tray.
See figure 12.
4. Plug the power seat switch cable (if so equipped) into the
connector on the utility tray.
5. Secure the controller cable to the armrest receiver with one or
more wire ties.
CAUTION! Do not place the controller cable so that it
can be pinched in the seat frame or the power base
frame.
22
V . A S S E M B L Y
Quantity
4
1
4
www.pridemobility.com
ATTACH
SEATBACK
HERE
Figure 9. Seatback Assembly
SLIDE SEAT ONTO TOWERS
Figure 10. Rear Seat Towers
LOCK SEAT INTO PLACE HERE
Figure 11. Front Seat Towers
Jazzy 1120/RevE/Feb03