Kenwood KRC-435 Instruction Manual page 26

W Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the two
locks on the lower level.
Lower the frame and pull it forward as shown In the figure.
/
h Accessory@
Removal tool
2 When the lower level IS removed, remove the upper two
locations.
f
@
The frame can be removed from the top side in the same manner
n
1
2
3
4
Removing the Unit
Refer to the section "Removing the hard rubber frame" and then
remove the hard rubber frame.
Remove the screw (M4 x 8) on the back panel.
Insert the two removal tools deeply into the slots on each side,
as shown.
Screw iM4X8)
(commercially
available)
Removal tool
Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
A Be careful to avoid injury from
the catch pins on the removal
tooi.
5 Pull the unit all the way out
with your hands, being
careful not to drop It.
- 26 -