Kenwood KRC-435 Instruction Manual page 25

n Installation
Frrewall or metal support
Screw fM4X8)
(commercrally
ava!lable)
n Installing in Japanese-Made Cars
1
Refer to the section "Removing the hard rubber frame" (page 26)
and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory
screws.
Bend the tabs of the
mountina sleeve
wrth a screwdriver or
/
\
simrlar utensil and
Self-tapping screw
Metal mountrng strap
attach It rn place.
fcommercrally avariable)
fcommercrally avariable)
T Toyota cars
N: Nissan cars
\
AccessoryGj for Nrssan car
Accessory@ .for Toyota car
A
l
During installation, do not use any screws except for those provided
The use of different screws might result rn damage to the mart- unrt
l
Damage may occur If a screwdriver or srmrlar tool IS used with
excessrva force durrng the rnstallatrons.
Make sure that the unrt IS Installed securely rn place. If the unit IS
unstable, rt may malfunctron (for example, the sound may skip)
W Screwing the Faceplate on the Unit
If you want to fasten the
faceplate to the main unit so
that It does not fall off,
screw in the provrded
screws (04 X 16 mm) in the
holes shown below.
A
Never Insert the taptrte screw
(04
x 16 mm) rn any other screw hole
than the one specrfled. If you screw it rn another hole, it wrll contact
and may cause damage to the mechanrcal parts Inside the unit
- 25 -