THE SCHWINN IC BIKE MAINTENANCE
n Daily maintenance
FIG.11
Dry the Schwinn IC Bike after each use to remove sweat and
moisture. Wipe your Schwinn IC Bike regularly with a mild, non-
abrasive cleaner and water solution. Rinse to remove detergent
residue and then dry.
IMPORTANT!
Bike, never use a petroleum-based solvent when cleaning.
n Chain adjustment
The chain on your Schwinn IC Bike has been
factory set and lubricated. It should not require any immediate
FIG.12
attention. Over time however you may need to make minor
tension adjustments.
1. With an adjustable wrench, loosen the two bolts on either
side of the flywheel. (Fig. 11)
2. Tighten the two smaller nuts which go through the frame
tube evenly by turning clockwise until there is approximately
3/16" of slack in the chain (Fig. 12).
3. Tighten the two larger nuts on the sides of the flywheel (Fig.
11).
To avoid damaging the finish on your Schwinn IC