Important Installation Instructions; Step - Capital PSGR244 Installation Manual

important installation instructions

INTRODUCTION:
Capital's Performance Series™ Gas Ranges are tested and approved in accordance with ANSI Z21.1b-2003/CGA IR
58, 1995, Household Cooking Appliances. It is STRONGLY RECOMMENDED that this appliance be installed in
conjunction with a suitable overhead VENT HOOD. Due to the high heat output of this unit, particular attention should
be paid to the hood and ductwork installation to assure it meets local building codes.
NOTE:
Local building
codes vary.
Cabinet storage
above the unit
should be avoided
to prevent the risk
of accidental fire
or burns.
special instructions for Massachusetts:
In the COMMONWEALTH OF MASSACHUSETTS, GAS CONNECTION MUST BE PERFORMED BY A
LICENSED PLUMBER OR GAS FITTER.
Installation, electrical
grounding and gas connections must
comply with all applicable codes. In the
absence of local codes, the unit should be
installed in accordance with the National
Fuel Gas Code
NFPA54-CURRENT ISSUE and National
Electrical Code ANSI/NFPA70-CURRENT
ISSUE.
ENSURE THAT THE
COMPATIBLE WITH GAS SUPPLY AT
THE INSTALLATION
PROCEEDING FURTHER. Return the unit
to the dealer if it is not set for the proper gas
supply available at the installation site.
IMPORTANT:
A back guard must be utilized when there is
less than 12" horizontal clearance between
combustible materials and the back edge of
the range. The Capital PERFORMANCE
SERIES™ Low Back must be ordered
separately and installed at the rear of
the range. For island installations and
other installations with more than 12"
clearance, an optional
Island Trim is available to
back-guard mounting flanges.
connections,
ANSI Z223.1/
RANGE IS
SITE BEFORE
stainless steel
cover the
2
GAS SUPPLY:
Natural Gas: 6-inch water column.
(14.9mb) Min., 8 inch (20mb) nominal
Propane Gas: 11-inch water column.
(27.4mb), 14 inch (37mb) maximum
ELECTRIC POWER SUPPLY:
PSGR244 model –
120 VAC, 60 HZ. 1 Ph., 10 Amp Circuit
PSGR304 model –
120 VAC, 60 Hz., 1 Ph., 10 Amp Circuit
PSGR36 models –
120 VAC, 60Hz., 1 Ph., 10 Amp Circuit
PSGR48 models –
120 VAC, 60 Hz., 1 Ph., 10 Amp Circuit