ProForm 14.0 CE User Manual page 27

HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip while you are pedaling,
even when the resistance is adjusted to the highest
level, the drive belt may need to be adjusted.
To adjust the drive belt, first unplug the power cord.
Using a flat screwdriver, release the tabs on the
Access Cover (20) and pry the Access Cover upward
off the elliptical.
88
13
83
50
83
Next, lift the Latch (50) on the underside of the Left
Pedal Arm (13), and then lift the Left Pedal Arm off the
left Pedal Arm Sleeve (46).
Then, remove the four M4 x 16mm Round Head
Screws (88) and the four M4 x 42mm Screws (83)
from the Right and Left Shields (18, 19). (Note: Not all
Screws are shown. Be sure to note which size Screws
come from which holes.) Then, carefully remove the
Left Shield.
20
18, 19
46
Loosen the Pivot Screw (97). Next, tighten the Belt
Adjustment Screw (85) until the Drive Belt (38) is tight.
When the Drive Belt is tight, tighten the Pivot Screw.
When you are finished, reattach the left shield, replace
the left pedal arm, and reattach the access cover.
Then, plug in the power cord.
27
Meijer.com
38
97
85