IBM System x3550 M4 Installation And User Manual page 82

10. Remove the PCI filler panel, if one is present, from the rear of the server.
11. Align the PCI riser-card assembly with the PCI riser connector on the system
66
IBM System x3550 M4 Type 7914: Installation and User's Guide
LEDs inside the server on the system board; then, see the Problem
Determination and Service Guide for information about how to solve the
problem.
3. Remove the cover (see "Removing the cover" on page 50).
4. Grasp both ends or the handle of the PCI riser-card assembly and lift it out of
the PCI riser-card slot on the system board.
5. If an adapter is installed in the riser-card assembly, disconnect any cables that
are connected to the adapter.
6. Remove the adapter, if one is present, from the PCI riser-card assembly.
7. Set the adapter and the PCI riser-card assembly aside.
8. Install the adapter in the new PCI riser-card assembly (see "Installing an
adapter" on page 67).
9. Set any jumpers or switches on the adapter as directed by the adapter
manufacturer.
board; then, press down firmly until the riser-card assembly is seated correctly
in the connector on the system board.