Operator information panel cable connection
The following illustration shows the internal routing and connector for the operator
information panel cable. The following notes describe additional information you
must consider when you install or remove the operator information panel cable:
v To remove the operator information panel cable, slightly press the cable toward
v To connect the operator information panel cable on the system board, press
the fan cage; then, pull to remove the cable from the connector on the system
board. Pulling the cable out of the connector by excessive force might cause
damage to the cable or connector.
evenly on the cable. Pressing on one side of the cable might cause damage to
the cable or connector.
Chapter 2. Installing optional devices
49