IBM System x3550 M4 Installation And User Manual page 116

4. Install the ServeRAID adapter on the system board (see "Installing a ServeRAID
5. Connect one end of the battery cable to the RAID adapter battery connector.
6. Route the remote battery cable along the chassis.
7. Install the battery:
100
IBM System x3550 M4 Type 7914: Installation and User's Guide
SAS/SATA controller" on page 71) or install the ServeRAID adapter on the riser
card and install the riser-card assembly in the server (see "Replacing a PCI
riser-card assembly" on page 65).
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.
a. Align the battery cable connector with the slot on the battery holder. Place
the battery into the battery holder and make sure that the battery holder
engages the battery securely.