IBM System x3550 M4 Installation And User Manual page 126

v System Settings
110
IBM System x3550 M4 Type 7914: Installation and User's Guide
Select this choice to view or change the server component settings.
– Adapters and UEFI Drivers
Select this choice to view information about the UEFI 1.10 and UEFI 2.0
compliant adapters and drivers installed in the server.
– Processors
Select this choice to view or change the processor settings.
– Memory
Select this choice to view or change the memory settings.
– Devices and I/O Ports
Select this choice to view or change assignments for devices and input/output
(I/O) ports. You can configure the serial ports, configure remote console
redirection, enable or disable integrated devices. If you disable a device, it
cannot be configured, and the operating system will not be able to detect it
(this is equivalent to disconnecting the device).
– Power
Select this choice to view or change power capping to control consumption,
processors, and performance states.
– Operating Modes
Select this choice to view or change the operating profile (performance and
power utilization).
– Legacy Support
Select this choice to view or set legacy support.
- Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does
not support UEFI video output standards.
- Rehook INT 19h
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant. The default is Enable.
- Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy
boot order. The default is Disable.
- BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The
default is Enable.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module
Select this choice to view or change the settings for the integrated
management module.
- Power Restore Policy
Select this choice to set the mode of operation after the power lost.
- Commands on USB Interface