Honda CRF250X 2007 Owner's Manual & Competition Handbook page 64

5. Install the clutch pressure plate (7).
6. Install the five clutch springs and clutch
spring bolts (8).
7. Tighten the bolts in a crisscross pattern in two
or three steps to the specified torque:
9 lbf·ft (12 N·m, 1.2 kgf·m)
(8)
(7) clutch pressure plate
(8) clutch spring bolts/clutch springs
8. Install a new O-ring (9) in the groove of the
clutch cover (10).
9. Install the clutch cover by tightening the
clutch cover bolts to the specified torque:
7 lbf·ft (10 N·m, 1.0 kgf·m)
(10)
(9)
(9) O-ring (10) clutch cover
10.Apply grease to the rear brake pedal pivot bolt
sliding surface.
11. Install the rear brake pedal (12), dust seals
(11), washer (15) and pivot bolt (13) and
tighten the pivot bolt to the specified torque:
27 lbf·ft (36 N·m, 3.7 kgf·m)
Connect the brake pedal return spring (14) if
it was removed.
12. Insert the pin (16).
(7)
(16)
(14) (15)
(11) dust seals
(12) rear brake pedal
(13) pivot bolt
13. Fill the crankcase with transmission oil (page
47).
(12)
(13)
(11)
(14) return spring
(15) washer
(16) pin
Clutch System
59
Servicing Your Honda