Table of Contents
Advertisement
INSTALLING HYDRAULIC MOTOR
1. Elevate the rear of the unit approx. 2' to prevent
oil from running out of gearbox
2. Remove gearbox shipping cover(00776159)
and bolts and discard.
3. Replace gasket (2) with new gasket included in
motor kit.
4. Verify that motor part number matches order.
Description
Low volume
Medium volume
High volume
5. Align Motor with return (Tank Port) facing
discharge side of Mower
6. Hand thread four 1/2" x 1-1/2" grade 8 bolts and
lockwashers into spindle.
7. Ensure that motor is fully seated and evenly
tighten the four mounting bolts to 80ft. lbs.
8. Connect Hydraulic hoses to Motor Check to
ensure
hoses
and
contamination.
9. With deck on a level surface check lubrication
level in gearbox per dip stick.
10. Apply
Decal
(16)
identification. (Refer to Figure Asm-R-0276)
SM72 02/10
© 2010 Alamo Group Inc.
ASSEMBLY
Part
00777954
00777953
00777952
motor
are
free
of
to
mower
deck
for
Assembly Section 3-4
Advertisement
Table of Contents
