Table of Contents
Advertisement
TROUBLE
Gear Box Leaking
Streaking Conditions
Blades Bolts
Blades Wears Too Fast
SM72 02/10
© 2010 Alamo Group Inc.
OPERATION
POSSIBLE CAUSE
1. Damaged oil seal.
2. Bent shaft.
3. Shaft rough in oil seal area.
4. Oil seal installed wrong.
5. Oil seal not sealing in the
housing.
6. Oil level too high.
7. Sand hole in casting.
8. Gasket damaged.
9. Bolts loose.
1. Conditions too wet for
cutting.
2. Dull blades.
3. Height of cutter lower at
Instructions.
1. Bolts not tightened.
2. Bolt hole elongated or
oversized.
3. Locknut worn out.
1. Cutting in sandy conditions.
2. Cutting in rocky conditions.
Operation Section 4-32
POSSIBLE REMEDY
Replace seal.
Replace oil seal and shaft.
Replace or repair shaft.
Replace seal.
Replace seal or use a sealant on
OD of seal.
Drain oil to proper level.
Replace castings or gear box.
Replace gasket.
Tighten bolts.
Allow grass to dry before cutting
Slow groundspeed of tractor but keep
engine running at full PTO rpm.
Cutting lower may help.
Sharpen or replace blades.
See Cutting Height rear or front.
Tighten bolts to 250 ft.lbs.
Replace Bushing or
Blade Carrier.
Replace Locknut.
Increase cutting height.
Increase cutting height.
Advertisement
Table of Contents
